ACRIFIX®1S 0117
( ACRIFIX® 117 )

ACRIFIX®1S 0117 ( ACRIFIX® 117 )

Product and Use Type
Thin-bodied, clear, colorless to slightly yellowish solvent adhesive( one –component)

Applications
For making T-bonds and bonding narrow areas of all kinds of uncrosslinked PLEXIGLAS, but also for other plastics such as PS, SBC, ABS, PVCu ,CAB.

ACRIFIX 117 is not gap-filling. The bond is firm within a short time. Rapid further treatment possible. High ultimate strength, conduct prior tests if necessary.

Typical Values
Viscosity; Brookfield A/60/20 ⁰C : ~ 0.8 mPa • ѕ
Density / 20 ⁰C : ~ 0.98 g/cm3
Refractive Index nD20: ~ 1.38
Color : Clear to yellowish, color does not of affect Bonding properties
Flash point DIN 53213 : < 4 ⁰C
Solids content : ≤ 1%
Storage stability : 2 years after filling, if correctly stored
Packaging material : glass and aluminum bottles (with inside coating )
Curing : absorption in the bonded articles

Safety Measures and Health Protection
Labeling acc. to Directive 1999/45/EC: Highly flammable (F), Harmful(Xn). Contains ethl formiate and nitroethane. Harmful by inhalation and swallowing irritating to eyes and respiratory system. Keep containers in a well-ventilated place, away from sources of ignition. No smoking. Avoid contact with eyes and skin. Take precautionary measures against static discharges. In case of fire and/ or explosion, do not breathe fumes

Storage / Transport
Keep container tightly closed in a cool place. Max. storage temperature 30 C.

Working Instructions
Normally, a sawn or milled edge of one article is bonded at right angles to the original surface of another. In areas where a high stress level is to be expected. Avoid bonding or anneal the parts beforehand to relieve stress.

The parts to be bonded must have a very accurate fit. Grooves and notches are not filled. Clean the adherends with petroleum ether or isopropyl alcohol before applying the adhesive.

Either of two methods may be used:
a) Lock the two parts in position without adhesive and introduce ACRIFIX 117 into the joint from a small nozzled bottle. The adhesive penetrates the joint by capillary action. From a sheet thinkness of ).5 mm on wards, the pass should first be put together with the aid of spacers ( e.g. stainless steel wire, 0.1 to 0.5 mm) at right angles to the sheet edge, which are pulled out after introduction of the adhesive.

b) The appropriate edge of one of the parts to be bonded is dipped into ACRIFIX 117 and placed in contact with the second part after allowing sufficient time for solvent action – PLEXIGLAS XT about 30 sec. PLEXGLAS XT about 30 sec. PLEXIGLAS GS about 60 sec.

After a short holding time, the bond is locked in position.

When bonding sawn edges, bubble formation can be reduced by passing the edges over with a scraper or smoothing them with fine abrasive paper

Product Range

Arcylic

Polycarbonate

Polypropylene

Aluminium Composite Panel

Light Fixtures

Super Slim Lightings & LED

Adhesive (Glue)

PVC Sheet

Accessories

Dama Trading Pte Ltd